This guide describes how to install the Enterasys
standard 19-inch equipment rack or in an industrial cabinet using a DIN rail. This guide also
explains how to interpret the system status LEDs to facilitate troubleshooting when necessary, and
also provides information on how to contact Enterasys Networks for additional help.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting up the
I-Series switch.
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents and to gain an
understanding of the features and capabilities of the I-Series Industrial Ethernet Switch. A general
working knowledge of data communications networks is helpful.
For information about...
Features and capabilities of the I-Series switch
Installation instructions, including installing in a rack, adding a second
Input/Output Module (IOM), connecting power, and connecting cables
Troubleshooting instructions, including checking the LEDs and replacing
the IOM in slot 1
Environmental and operating specifications for the I-Series switch and
IOMs
Related Documents
To configure the I-Series switch, refer to the Enterasys I-Series CLI Reference Guide.
Manuals can be accessed on the World Wide Web, using the following URL:
https://extranet.enterasys.com/downloads
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Eléctrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
About This Guide
®
I-Series Industrial Ethernet Switch in a
Chapter
Chapter
Chapter
Appendix
and Regulatory Compliance
Enterasys I-Series Hardware Installation Guide xv
Refer to...
1,
Introduction
2,
Installation
3,
Troubleshooting
A,
Specifications