Replacing The Iom In Slot 1; Removing The Iom - Enterasys I Series Hardware Installation Manual

Replacing the IOM in Slot 1

To replace the IOM in slot 1:
1. If necessary, remove the switch from the rack or DIN rail, as described in
Switch from a
2. Place the switch on a secure location and turn it upside down.
3. Remove the bottom cover by removing the screws from the bottom and the side, as shown in
Figure
Figure 3-5
1 Bottom panel
2 IOM
3 IOM front panel screws
Rack" on page 3-5 or
3-5. You do not need to remove the screws holding the access panel in place.

Removing the IOM

"Removing the Switch from a DIN
4 Heat block
5 IOM rear screws
Enterasys I-Series Hardware Installation Guide 3-7
Replacing the IOM in Slot 1
"Removing the
Rail" on page 3-6.