Using AT&TConnect
2.
Select the appropriate information, and then select the Continue button.
If you do not have a PARTNER II Release 3.0 or later system, the
AT&TConnect Setup - Line Labels dialog box appears. In this case,
proceed to step 4.
If you have a PARTNER II Release 3.0 or later system, the
AT&TConnect Setup - Caller ID Inspect Feature dialog box appears.
3.
Select the Continue button.
The AT&TConnect Setup - Line Labels dialog box appears.
4.
Select the Continue button.
The AT&TConnect Setup dialog box appears.
5.
Select the OK button.
Changing the Labels of the Line Buttons
To change a line button label:
NOTE:
You cannot change line button labels while PassageWay
applications other than AT&TConnect are running.
1.
Select Configure System. . . from the Setup menu.
The AT&TConnect Setup - System Configuration dialog box appears.
7-8