Removing A Qsfp+ Transceiver - Avaya Virtual Services Platform 7000 Series Installation Manual

Installing transceivers and optical components
Hide thumbs Also See for Virtual Services Platform 7000 Series:
Table of Contents

Advertisement

QSFP+ transceivers
Job aid
Depending on the transceiver manufacturer, QSFP+ transceivers use bail-latch or pull-tab types of
locking and extractor mechanisms.
The following figure shows the pull-tab release mechanism used on Avaya QSFP+ transceivers.
Other release mechanisms do exist. In the following figure, the bore plug remains in the QSFP+.
Pull the tab to release the device, with the fiber connector still attached.

Removing a QSFP+ transceiver

Remove a QSFP+ transceiver to replace it or to commission it elsewhere.
Before you begin
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
Electrostatic alert:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an electrostatic discharge (ESD) jack.
Procedure
1. Grasp the pull-tab and slide the QSFP+ transceiver out of the module QSFP+ slot.
Installing Transceivers and Optical Components on Avaya VSP 7000 Series
62
Comments? infodev@avaya.com
August 2014

Advertisement

Table of Contents
loading

Table of Contents