Avaya Virtual Services Platform 7000 Series Installation Manual page 37

1000BASE-T SFP specifications
The 1000BASE-T SFP provides gigabit Ethernet connectivity using a single eight-pin RJ-45
connector. The 1000BASE-T SFP only operates at 1 Gb/s and does not support 100BASE-T or
10BASE-T interfaces. The part number for this model is AA1419043-E6.
Important:
You must disable autonegotiation before you operate the 1000BASE-T SFP. After you insert
SFPs into certain product-specific modules, the system activates autonegotation by default.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 2: IEEE 802.3z 1000BASE-T SFP specifications
Parameter
Standards
Connectors
Cabling
Distance
1000BASE-SX DDI SFP specifications
The following table describes the 1000BASE-SX DDI SFP, which has a reach of up to 550 m using
50 µm MMF, and of 275 m using 62.5 µm MMF. This SFP operates at 850 nm. The part number of
this SFP is AA1419048-E6.
Table 3: 1000BASE-SX SFP DDI (550 m) specifications
Parameter
Maximum electrical power consumption
Connector
Cabling
Data rate
Line rate (8B/10B code)
Link optical power budget
Transmitter characteristics
Launch power
Receiver characteristics
Receiver sensitivity
Maximum receiver power
1000BASE-LX DDI SFP specifications
This SFP provides 1000BASE-LX gigabit Ethernet connectivity at 1310 nanometers (nm) using
single mode or multimode optical fiber. The part number of this SFP is AA1419049-E6.
August 2014 Installing Transceivers and Optical Components on Avaya VSP 7000 Series
Comments? infodev@avaya.com
Specifications
IEEE 802.3z, IEEE 802.3ab
RJ-45
CAT5E or better UTP
Up to 100 m
Specifications
1 watt (W)
Duplex LC
MMF
1.0 Gb/s
1.25 Gb/s
7.5 dB
– 9.5 to -4.0 dBm
– 17 dBm
0 dBm
SFP specifications
37