Avaya Virtual Services Platform 7000 Series Installation Manual page 42

SFP
Parameter
Transmitter characteristics
Launch power
Receiver characteristics
Receiver sensitivity
Maximum receiver power
1000BASE DDI CWDM 40 km SFP specifications
The 1000BASE SFPs provides CWDM gigabit Ethernet connectivity using single mode fiber. These
SFPs support full-duplex operation only.
Important:
For the 40 km CWDM SFPs, a minimum attenuation of 4 dB must exist between the transmitter
and receiver. To avoid receiver saturation, you must insert a minimum attenuation of 4 dB when
you test the CWDM SFP in loopback mode.
The following table describes specifications for 1000BASE DDI CWDM SFPs numbered
AA1419053-E6 to AA1419060-E6.
Caution:
Risk of equipment damage
To prevent damage to the optical receiver, ensure that at least 4 dB of attenuation exists
between the transmit and receive ports.
Table 11: 1000BASE CWDM SFP DDI (40 km) specifications
Parameter
Maximum electrical power consumption
Connectors
Cabling
Data rate
Line rate (8B/10B code)
Link optical power budget
Maximum dispersion power penalty
Minimum attenuation between transmit and receive
ports
Transmitter characteristics
Launch power
Receiver characteristics
Receiver sensitivity
Maximum receiver power
Installing Transceivers and Optical Components on Avaya VSP 7000 Series
42
Specification
0 to 5.0 dBm
– 30 dBm
– 9.0 dBm
Specifications
1.0 W
Duplex LC
SMF, 9 µm
1.0 Gb/s
1.25 Gb/s
17 dB
1 dB at 40 km
4 dB
– 4.0 to 1.0 dBm
– 21 dBm
– 3.0 dBm
Comments? infodev@avaya.com
August 2014