Chapter 5
set console transfer ppp
Command Mode
Description
Syntax
To Enable:
Sample Output
Systems
5-8
Configuration
Transfers control of the serial console port and the CLI session to the
PPP protocol layer.
This command is only accepted when the console serial port is
configured in PPP mode.
When accepted, this command immediately terminates the current
CLI session, logs the user out, and switches the I/O on the serial
console port from the CLI processing software to the PPP layer. The
remote host also needs to simultaneously change its I/O to use PPP
software. This command is NOT stored (no back-end), and is only
for use when the user has successfully dialed-into the Cajun. This
command can only be accepted when the Console Serial Port is
configured in PPP mode.
The command cannot be accepted from a telnet session, it can only
be accepted over directly connected serial sessions, and most
preferably from a post-dial modem terminal session on the remote
host.
set console transfer ppp
Cajun(configure)# set console transfer ppp
P550/P550R/P880/P882
Cajun P550R/P880/P882 Command Reference Guide