Table of Contents
Advertisement
3. Connect all power cables to the server board.
Replacing the Backup Battery
The lithium battery on the server board powers the RTC for up to 10 years in the absence of power.
When the battery starts to weaken, it loses voltage, and the server settings stored in CMOS RAM in
the RTC (for example, the date and time) may be wrong. Contact your customer service
representative or dealer for a list of approved devices.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries according to
manufacturer's instructions.
Advarsel: Lithiumbatteri - Eksplosionsfare ved fejlagtig hå ndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levé r det brugte batteri tilbage til leverandø ren.
Advarsel: Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandø ren.
Varning: Explosionsfara vid felaktigt batteribyte. Anvä nd samma batterityp eller en ekvivalent typ
som rekommenderas av apparattillverkaren. Kassera anvä nt batteri enligt fabrikantens instruktion.
Varoitus: Paristo voi rä jä htä ä , jos se on virheellisesti asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppiin. Hä vitä kä ytetty paristo valmistajan ohjeiden mukaisesti.
1. Locate the battery on the server board.
2. Gently press the metal clip as shown to release the battery (see letter A).
3. Remove the battery from the plastic socket (see letter B).
®
Intel
Server System R1000EP Service Guide
Figure 69. Installing the Server Board
Server System Features
43
Advertisement
Table of Contents
