Figure 58.Installing the Intel® Integrated RAID Module RMS25JB0x0
5. Connect the proper cables into the adapter using the 4-port combined end. Make sure the
module and cables are properly attached and plug the cable into connector at the inside edge of
the adapter.
Note:To prevent throughput problems:
—Use the cables provided or use the shortest possible cable.
—Do not use cables longer than one meter.
—Decrease the maximum length by one foot if you are using a backplane.
—Do not use cross-over cables.
—Only connect to a SATA drive, SAS or SATA backplane, or anexpander device.
—Route the cables carefully.
—Check that the module and cables are all properly attached.
®
Intel
Server System R1000EP Service Guide
Server System Features
37