Table of Contents
Advertisement
General Installation Process
12
Install Rack Handles
NOTE: Rack handles are required to install the bezel. For detailed
instructions, see the Service Guide.
14
Install Intel® Remote Management Module 4 (optional)
Install Intel® RMM4 Lite
Locate the RMM4 Lite connector, carefully
pickup the Intel
®
RMM4 Lite module,
match the alignment pin of the module
and the connector on server board, then
press to install.
15
Install Intel® RAID Smart Battery (optional)
A
Position the battery against the side wall.
B
Align the tabs on the plastic battery holder with the mounting holes in the
chassis and slide the plastic battery holder toward the front of the system
until the tabs engage with the mounting holes.
A
Remove the filler Panel and Retention Device refer to STEP 11.
B
Attach the RMM4 module with two screws as shown.
C
Fasten the bracket with one screw as shown.
D
Connect one end of the flex cable
to the RMM4 connector on the
RMM4 NIC module.
E
Connect the opposite end of the
flex cable to the RMM4 connector
on the server board.
Note: The cable connectors are
keyed and can only go in one way.
13
Install Intel® RAID C600 Upgrade
Key (optional)
Locate the white 4-pin key header. Carefully pickup the Intel
Key. Match the Key and connector orientation and press down to install.
Install Intel® RMM4 NIC
B
E
B
7
®
RAID C600 Upgrade
C
Retention Device
A
Filler Panel
D
A
Advertisement
Table of Contents
