Table of Contents
Advertisement
General Installation Process
13
Install Add-in Card Riser Assembly
Position the riser card edge
connector over the server
board riser socket and align
the hook of the riser with the
slot at the back of the chassis,
then press straight down into
riser socket.
15
Install Intel® I/O Expansion Module
(optional)
A
Squeeze the sides of the filler panel to
disengage it from the server system
back panel and remove it.
B
Position the module over the server
board, fit the front of the module into
the back panel slot.
C
Attach the module to the server
board connector.
D
Secure the module with the three
screws as shown.
Note: If included, remember to install the EMI shield.
17
Install Intel® Remote Management Module 4 (optional)
Installing the Intel® RMM4 Lite
A
Locate the RMM4 Lite connector close to the Riser Slot.
Carefully pick up the Intel
®
pin of the module and the connector on server board. Press to install.
D
B
C
I/O Connector
RMM4 Lite module, match the alignment
14
Hooks
Slots
16
Install Intel® RAID C600
Upgrade Key
(optional)
A
Locate the white 4-pin key,
carefully pick up the Intel
C600 Upgrade Key. Match the
key and connector orientation
and press down to install.
Installing the Intel® RMM4 NIC
Push out and remove the
A
metal cover on the chassis
where the NIC RJ-45
receptacle will align.
B
Position the module over
the server board.
Fit the front of the
module into the back
panel slot.
Attach the module to the
RMM 4 NIC
server board connector.
Connector
C
Secure the module with
the two screws as
shown.
8
Install Rack Handles
Note: Rack handles are required to install
the bezel. For detailed instructions, see the
Service Guide.
®
RAID
A
C
B
Chassis
Back
Opening
Filler
Advertisement
Table of Contents
