Table of Contents
Advertisement
Chapter 3
browse the web site through your web browser.
If the LEDs do not illuminate as expected or the web page is not
displayed, see Appendix 12 for troubleshooting suggestions.
3.3.3 Default Router Settings
In addition to handling the DSL connection to your ISP, the iPBX30
can provide a variety of services to your network. The device is pre-
configured with default settings for use with a typical home or small
office network.
The table below lists some of the most important default settings;
these and other features are described fully in the subsequent
chapters. If you are familiar with network configuration settings,
review them to verify that they meet the needs of your network.
Follow the instructions to make changes if necessary. If you are
unfamiliar with these settings, try using the device without making
any modification, or contact your ISP for assistance.
Before you modifying any settings, review Chapter 4 for general
information about accessing and using the Web UI Management
program. We strongly recommend that you contact your ISP prior to
changing the default configuration.
Option
DHCP
(Dynamic Host
Configuration
Protocol)
LAN Port IP
Address
22
Table 3.2 Default Settings Summary
Default Setting
DHCP server enabled
with the following pool
of addresses:
192.168.1.100 through
192.168.1.200
Static IP address:
192.168.1.1
subnet mask:
255.255.255.0
iPBX30 User Manual
Explanation/Instruction
The iPBX30 maintains a pool of
private IP addresses for dynamic
assignment to your LAN computers.
To use this service, you must
have set up your computers to
accept IP information dynamically,
as described in section 3.2. See
section 6.1 for an explanation of the
DHCP service.
This is the IP address of the LAN
port on the iPBX30. The LAN
port connects the device to your
Ethernet network. Typically, you will
not need to change this address.
See section 5.1 for instructions.
Advertisement
Table of Contents
