Configuring Static Ip For Wan Or Dmz - Asus iPBX30 User Manual

Chapter 5
Setting
Subnet Mask
Gateway Address
Primary/ Secondary
DNS Server
MTU
5.2.5.2 Configuring Static IP for WAN or DMZ
Follow the instructions below to configure static IP settings:
1. Click the Router Setup -> Connection menu to open the
Network Setup configuration page.
2. Select which WAN port (WAN1/WAN2) or DMZ port to configure
for the static connection mode.
3. Select Static from the Connection Mode drop-down list.
4. Enter WAN IP address in the IP Address field. This information
should be provided by your ISP.
5. Enter Subnet Mask for the WAN. This information should be
provided by your ISP. Typically, it is 255.255.255.0.
6. Enter gateway address provided by your ISP in the space
provided.
7. Enter the IP address of the primary DNS server. This information
should be provided by your ISP. Secondary and third DNS
servers are optional.
8. (Optional) Change the MTU value if necessary. If you do
not know what value to enter, leave it as it is. For static IP
connection mode, the range of MTU is from 576 to 1500. The
default value is 1500.
9. Click Apply to save the settings
38
Description
WAN/DMZ subnet mask. Typically, it is set as
255.255.255.0.
Gateway IP address provided by your ISP. It must be in
the same subnet as the WAN on the iPBX30.
You must at least enter the IP address of the primary
DNS server. Secondary DNS server is optional
You may specify the maximum size of the transmitted
packet. For static IP connection, the range of MTU is
from 576 to 1500. The default value is 1500.
iPBX30 User Manual