Table of Contents
Advertisement
Chapter 9
Table 9.5. Virtual Server Configuration Parameters
Setting
ID
Add New
Number
Move to
This option allows you to set a priority for virtual server rule check. NAT
does the IP and/or port mapping based on the priority of the rules. Set a
priority by specifying a number for its position in the list of rules
1 (First)
Other
numbers
Destination
This option allows you to set the destination network to which this rule
should apply. Use the drop-down list to select one of the following options:
IP Address
Interface
Service
Redirect IP
80
Description
Click on this option to add a new virtual server.
Select the ID of a virtual server from the drop-down list to
modify its settings.
This number marks the highest priority.
Select other numbers to indicate the priority you wish to
assign to the rule.
Enter the IP address of the virtual server if the virtual
server has a known public IP address.
Use the IP address of the selected interface as the
destination IP address. Available options are:
eth1 (WAN1)
eth2 (WAN2)
ppp1 (WAN1 – unnumbered)
ppp2 (WAN2 – unnumbered)
ppp3 (WAN1 – PPPoE 1)
ppp4 (WAN1 – PPPoE 2)
ppp5 (WAN2 – PPPoE 1)
ppp6 (WAN2 – PPPoE 2)
Select a service, from the drop-down list, to which this rule
should apply. If the desired service is not listed, click on
the Edit button to create a new service.
Enter the IP address of the computer (usually a server in
your LAN) that you want the incoming traffic to be directed.
For example, if IP address of the web server on your LAN
is 192.168.1.28, please enter 192.168.1.28 here.
iPBX30 User Manual
Advertisement
Table of Contents
