Chapter 5
Follow the instructions below to set up WAN load balancing:
1. Click the Router Setup ->Load Balance menu to open the
Load Balancing configuration page.
2. Select Auto Mode in the Load Balance field.
3. Enter the ratio of the traffic amount that you want to distribute
between the two WANs. The allowable value is from 0 to 100%.
The sum of the two numbers is 100%.
4. Select whether you need to enable or disable connectivity
check. If this option is enabled, please also enter the following:
a) Enter the connectivity check interval.
b) (Optional) Enter the connectivity check IP address for WAN1
and/or WAN2.
5. Click Apply to save the settings.
5.3.3 Setting Up WAN Line Back Up
Follow the instructions below to set up line backup:
1. Click the Router Setup ->Load Balance menu to open the
Load Balancing configuration page.
2. Select "Line Backup" in the Load Balance field.
3. Select whether you need to enable or disable connectivity
check. If this option is enabled, please also enter the following:
a) Enter the connectivity check interval.
b) (Optional) Enter the connectivity check IP address for WAN1
and/or WAN2.
4. Click Apply to save the settings.
44
iPBX30 User Manual