Table of Contents
Advertisement
iPBX30 User Manual
5.2.6 PPTP
Some service providers require user to login using PPTP
connection.
5.2.6.1 WAN PPTP Configuration Parameters
The table below describes the configuration parameters available
for PPTP connection mode.
Table 5.5. WAN PPTP Configuration Parameters
Setting
Description
Link
Select a port to configure. Available options are WAN1,
WAN2 or DMZ.
Connection
Select PPTP from the connection mode drop-down list.
Mode
WAN Interface
Select how WAN IP address is to be configured – static
IP
(manually set the IP address) or dynamic (obtained
automatically from the DHCP server).
Static
Choose this connection mode if the WAN IP is a fixed IP
provided by your ISP.
IP Address
Enter the WAN IP address provided by your ISP.
Subnet Mask
Enter the subnet mask for the WAN IP provided by your ISP.
Gateway
Enter the gateway IP address for the WAN provided by your
ISP.
Address
Dynamic
Select this connection mode if your WAN IP address is
obtained automatically from your ISP's DHCP server.
(DHCP)
User Name and
Enter the username and password you use to log into your
Password
ISP. (Note: this is different from the information you used to
log into the software application.)
Server IP
Enter the PPTP server IP address provided by your ISP.
Address
MTU
You may specify the maximum size of the transmitted packet.
For PPTP, the range of MTU is from 546 to 1460. The default
value is 1460.
Connect on
Click on the Enable or Disable radio button to enable or
disable this option.
Demand
Chapter 5
39
Advertisement
Table of Contents
