Lcd Display; Lid - Hitachi RZ-V100CYH Operating Instruction And Cook Book

Troubleshooting - continued
Problem
●Cannot reheat
●Suddenly
changes
●Not displayed
●The pressure
display (
is flashing.
●"–:– –" or "H0"
appears.
●The display will
go off when the
power plug is
disconnected
from the outlet
socket.
●The display
dims when the
power plug is
unplugged.
●"C1" or "C2"
appears.
●"C3" or "C4"
appears.
●Something between
"H1" and "H12"
appears.
E-40
If the rice is hot after the cooking process is completed or if Keep Warm is
canceled and the rice is cold, a beep will be emitted and Reheating will be
disabled.
The cooking process is automatically adjusted to make the rice taste
delicious. For this reason, the displayed cooking time may suddenly change
during the cooking process. This is not a malfunction.
The current time is displayed when you select any program other than
"Normal", "Rapid", or "Eco" for "White", or "Normal" for "Mixed Grain". The
current time is also displayed when the body of the rice cooker is hot.
The cooking process is interrupted.
●This flashes for approximately 30 seconds when the "Cancel/off" button is pressed or the
)
appliance is unplugged during pressure cooking. Do not open the lid while this is flashing.
If you need to open the lid for unavoidable reasons, see
If "–:– –" appears, readjust the current time.
When the "Cancel/off" button is pressed with the display showing "H0", the
display will change to "–:– –".
Please reset the current time.
The cooker is configured to deactivate the display when it is unplugged and to activate it
when it is plugged. This is not a malfunction.
If the LCD display goes off when it has been configured to stay active after the appliance
is unplugged, or if "–:– –" or "H0" is displayed when the appliance is plugged in, the
built-in lithium battery is almost dead. The Cooking and Keep Warm are available,
however, Timer Cooking is not available unless you adjust the current time. To arrange a
replacement of the lithium battery, please contact your local dealer. You are liable for the
cost of replacement. (Do not attempt to replace the lithium battery by yourself.)
If the appliance has been configured to use its built-in battery to power the
LCD display, the display may dim when the appliance is unplugged and may
return to normal when it is plugged in again. This is because the power to
the display is switched to the built-in battery, and is not a malfunction.
This will appear and the supply of power will be stopped when the voltage
drops because an extension cord is used or another appliance is plugged
into the same power outlet. Use a dedicated power outlet and do not use an
extension cord.
They appear if the lid is not closed correctly. Be sure to close the lid
correctly.
If the display does not return to the time display when you press the "Cancel/off"
button, or if the same display appears frequently, ask your local dealer to repair it.
Please check the following before
requesting repairs.
Cause or Remedy
P.E-29
.
P.E-25
P.E-14
P.E-15