If You Are Concerned About Odors - Hitachi RZ-V100CYH Operating Instruction And Cook Book

If you are concerned about odors

●If you are concerned about odors that have developed after you have cooked mixed rice or kept rice warm, boil water.
Steam generated from the boiling water can reduce the odors.
1
Place water in the inner pot.
●Fill the pot with water up to level 2 for "White Rice".
* Be sure to only use water.
2
Press
five seconds to switch to a mode
in which to change settings.
3
Press
●The display changes each time
●Press
to move to the next setting.
Press to move back to the previous setting.
(Setting the melody
of an alarm)
P.E-16
4
Press
●A melody is emitted, "60" is displayed,
and heating begins.
●The Cook/Reheat lamp lights up.
5
A melody (beep) is emitted when
Heating is completed.
●The Cook/Reheat lamp goes off.
6
Allow the rice cooker to cool down,
discard the hot water, and wipe off
any moisture on the inner pot.
Dirt on the inner pot or temperature sensor
●If the inner pot contains residual rinse water or rice grains, the sensor will not be able to correctly measure temperature.
Wipe off any moisture or foreign objects on the outside or bottom of the inner pot before placing it in the rice cooker.
Remove any dirt or foreign objects from the sensor.
Dirt on the inner lid
●If dirt or debris (e.g. mushed grains) has stuck to the lid packing on the inner lid, the correct pressure will not be applied,
which will prevent the rice from being cooked properly.
●Make sure that the regulator valve, safety valve, and vacuum valve are clean and not clogged.
E-34
for approximately
or to display "U1-".
or is pressed.
(Setting the LCD (If you are
(Setting Plate Condensation
concerned
display) Reduction mode)
about odors)
P.E-15 P.E-17
.
P.E-30, P.E-31
P.E-31, P.E-32, P.E-33
Lights up
Lights up
Goes off
P.E-31
●Pressing the "Cancel/off" button enables
you to return to the initial view even during
setup. Any settings you have not confirmed
will be reset.
If you are still
concerned about odors
Boil saltwater (approximately 1%) in a
1
pot or frying pan that is large enough
to hold the inner lid and plate.
2 When the water begins boiling,
turn the heat to Low and heat
the inner lid and plate for
approximately 15 minutes.
Discard the hot water and allow
3
the inner lid and plate to cool
down before washing them.
●Note that heating them in a pot
that does not contain a sufficient
amount of water could cause
their plastic parts to deform.
●The inner pot and inner lid are hot
right after boiling is finished. Allow
the cooker to cool down before
discarding the hot water and
wiping off any moisture.
●Some odors cannot be completely
removed.