Preparing The Rice Cooker - Hitachi RZ-V100CYH Operating Instruction And Cook Book

Preparing the Rice Cooker

1
Put the inner pot
into the rice cooker.
2
Check the lid.
●
If the non-water supply
auto steamer plate is not
attached, the intended
humidification effects
will not be achieved by
steam, and the rice may
be cooked a little hard.
3
Close the lid and
attach the steam
cap.
●
You do not need to
soak the rice before
cooking and leave it to
steam after the cooking
process is finished.
The "Soaking" and "Steaming"
processes are included in the
cooking process.
4
Insert the power
plug into a power
outlet
E-22
Wipe off any water, food, etc. that has stuck to the
outside or bottom of the inner pot before setting it
in the rice cooker.
If the inner pot is set without removing moisture and debris,
ATTENTION
a malfunction or unsatisfactory cooking quality may result.
Make sure that the regulator valve, safety valve, and
vacuum valve are clean and not clogged.
Remove
any debris.
Before starting cooking, remove the inner lid, plate, and steam vent top casing to
make sure that no rice or other debris has stuck to the regulator or safety valve.
Be sure to attach the plate and steam vent.
Warning
(Failure to do so could result in burns caused by hot water
bursting out, or the lid opening suddenly.)
Close the lid slowly and securely until it clicks
into position. Then, attach the steam cap.
To attach the steam cap,
align it with the depression in
the lid and press down on the
front center of the steam cap
until it clicks into position.
●
When closing the lid, be sure to press both sides of the
hook button until the lid clicks into position. (Failure to do so
could cause the lid to open suddenly, resulting in burns.)
●
Be sure to attach the steam cap.
Warning
(There is a risk that burns may result from the contents
boiling over or hot steam rushing out of the cooker.)
You may hear a zapping sound or see sparks fly when plugging in the power plug,
Note
however, this is due to the charging of the inverter circuit and is not a malfunction.
Wipe off any water or food on the outside.
Attach the non-water supply
P.E-31 auto steamer.
Steam cap
Steam vent
Click
The selected type of rice,
program, and the current
time are displayed.
P.E-32
ATTENTION
●
The lid will not close if it is
slammed because the lid of
the pressure rice cooker is
highly airtight (which means
air does not easily escape).
Close the lid slowly.
●
The lid will not close unless
the non-water supply auto
steamer is attached.