Repair And Maintenance - Razor E300 HD Owner's Manual

USAGE
How to Stop
1. To stop, release the throttle (B) and apply the brake, by squeezing the brake lever (C), until the product comes to
a complete stop.
2. Make sure to turn the product OFF after your ride is complete. Pressing the power switch (D) will turn the
product OFF completely.
B
C

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch OFF
Adjusting the Brake
Tool Required: 10 mm Wrench (not included)
1
To adjust the brake cable tension,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
• Secure the product under repair
• Exercise caution around
exposed parts
2
If the brake is too tight
or too loose, use a 10 mm
wrench to loosen the nut for
additional adjustment on the
brake cable. Securely tighten the
nut when finished.
D
• Contact Razor customer service
if unsure about any repair or
maintenance
7
WARNING:
The brake is capable of skidding
the rear wheel and throwing an
unsuspecting rider. Practice in an
open area free from obstacles until
you are familiar with the brake
function. Avoid skidding to a stop as
this can cause you to lose control
and/or damage the rear wheel.
Note: As an additional safety
feature, the scooter is designed to
cut power to the motor when the
hand brake is applied.
Note: Motor will re-engage,
(without having to kick start), if
brake is released and throttle is
engaged before scooter has slowed
down to under 3 mph (5 km/h).
Note: Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under the limited warranty.