Before You Begin - Razor E300 HD Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information).
Charger
(Note: Charger design may vary from
one shown)
3.
Required Tool
5 mm
Allen Wrench
Twist-Grip Throttle
Brake Lever
Limiter
Collar Clamp
Fork
ON/OFF Switch
2.
Charger Port
Reset Button
Handlebar Stem
1.
Battery
Control
Module
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The scooter
has been built to certain Razor
design specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame, fork and all other parts.
Certain aftermarket products
may not be compatible and will
void the warranty.
Note: Electric scooter must be
moving at least 3 mph (5 km/h)
while applying throttle to
engage motor.
Product ID Locations:
(See locations to the left)
1. Handlebar Stem
2. Underneath Battery Tray
3. Charger
4. UPC side of box (not shown)
Hub Motor
Plastic Bag Contents:
• Charger
• Tool
• Owner's Manual