Razor E300 HD Owner's Manual page 10

REPAIR AND MAINTENANCE
Front Tire Replacement
Tools Required: Two (2) 16 mm Wrenches (not included)
1
Using two (2) 16 mm wrenches, loosen the axle bolts by turning the wrenches counter clockwise. Remove wheel
and install replacement wheel. Note the sequence of the hardware.
Rear Wheel/Hub Motor/Battery Replacement
Tools Required: Phillips Screwdriver, 4 mm Allen Wrench, Two (2) 19 mm Wrenches, Two (2) 10 mm Wrenches,
Two (2) 8 mm Wrenches (not included)
B
A
A
B
A
1
Using a Phillips screwdriver and 4 mm Allen wrench
remove the six (6) screws and two (2) Allen bolts and
remove the deck plate. A: Small screw size, B: Allen
bolt, C: Large screw size
3
Disconnect the battery wire connector from the
control module and carefully remove the battery.
Note: If only replacing the battery, install new battery
and reverse steps 1-3.
5
With a 10 mm wrench, loosen the brake cable anchor
bolt and disconnect the cable.
1-6
1-5
1-3 1-4
1-1 1-2
C
C
A
2
Using a Phillips screwdriver remove the battery strap.
4
Disconnect the motor wire connector from the control
module and remove the wire from guider.
6
With two (2) 8 mm wrenches, remove the cable guide
bracket from the frame and brake plate. Keep the bolt,
washer, spacer, and nuts together.
1-3
1-4
1-5
8
Note: Front wheel
hardware sequence.
Right Side (Throttle)
1-1
1-5 Spacer
1-2
1-4 Washer
Fork
1-3 Washer
1-2 Spring Washer
1-1 16 mm Locknut
Middle
1-6 Front Axle Bolt
Left Side (Brake)
1-5 Spacer
1-4 Washer
Fork
1-3 Washer
1-2 Spring Washer
1-1 16 mm Locknut
Note: Color match wires.
5 Pin Connector - 5 Pin Connector
Blue - Blue
Yellow - Yellow
Green - Green