Repair And Maintenance; Adjusting The Brakes - Razor E300 Series Owner's Manual

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove Charger Plug
• Turn the power switch off
q Adjusting the Brakes
Tools required: 10 mm wrench
1
To adjust the brake cable
tension, thread the brake lever
adjuster in or out 1/4 to 1/2
turn until the desired brake
adjustment is attained. Most
adjustments are complete at
this step. If brake still needs
further adjustment, proceed to
step 2.
q Chain and Rear Tire Replacement
Tools required: Phillips screwdriver, 10 mm wrench, two (2) 8 mm wrenches, and two (2) 16 mm wrenches.
Disassembly
1
With a Phillips screwdriver,
loosen the 3 screws and remove
the chain guard.
4
With two (2) 16 mm wrenches,
loosen the axle locknuts. Push down
and remove wheel from the frame.
Remove chain from rear sprocket.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
If the brake is too tight or too
loose, use a 10 mm open wrench
to loosen the nut for additional
adjustment on the brake cable.
Securely tighten the nut when
finished.
2
With a 10 mm wrench,
loosen the brake cable anchor
bolt and disconnect the cable.
• Contact Razor customer
service if unsure about
any repair or maintenance
3
With two (2) 8 mm wrenches,
remove the cable guide bracket
from the frame and brake plate.
Keep the bolt, washers, and
nuts together.
WARNING:
The brake is capable of skidding
the rear tire and throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control and/or
damage the rear tire.
Rear wheel hardware
Note:
sequence.
17-1
17-2
17-3 17-4
17-5
17-6
17-9
17-7
17-8
17-3
17-2
17-1
Left Side (Brake)
17-1 Locknut
17-2 Spring Washer
17-3 Washer (thick)
Frame
17-4 Washer (thin)
17-5 Brake Plate
17-6 Spacer
Middle
17-9 Rear Axle Bolt
Right Side (Throttle)
17-7 Spacer
17-8 Washer (plate cut)
Frame
17-3 Washer (thick)
17-2 Spring Washer
17-1 Locknut