Repair And Maintenance - Razor 13111261 Owner's Manual

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
Adjusting the Brake
Required Tool: 10 mm Wrench (not included)
1
To adjust brake cable play, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
Replacing the Front Wheel
Required Tool: 10 mm Wrench and Two (2) 16 mm Wrenches (not included)
1
Using a 10 mm wrench loosen
the brake cable bolt.
Replacing the Chain and Rear Wheel
Required Tools: Phillips Screwdriver and Two (2) 13 mm Wrenches (not included)
1
Using a Phillips screwdriver,
loosen the two (2) screws on the
chain guard and remove.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
If brake is too tight or has too
much slack, use a 10 mm wrench
to loosen the brake cable and
adjust accordingly.
2
Using two (2) 16 mm wrenches,
loosen the locknuts by turning
the wrenches counter clockwise.
Remove wheel and install
replacement wheel.
(Note sequence of hardware.)
2
Using two (2) 13 mm wrenches,
loosen the locknuts by turning the
wrenches counter clockwise.
• Contact Razor customer service
if unsure about any repair or
maintenance
B
3
Inspect the brake pads (A) for
proper alignment against the wheel
or excess wear. To realign brake
pads, loosen the fixing nut (B) and
adjust the pad to contact the rim.
Re-tighten and readjust as needed.
Verify proper brake function prior to
riding the scooter.
3
Reassemble, adjust and tighten
brake cable. Verify proper brake
function prior to riding the scooter.
3
To loosen the chain, pushing
the tensioner down to create some
slack in the chain.
6
A
Note: Front wheel hardware
sequence
8-6
8-7
8-5
8-1
8-2
Right Side (Throttle)
8-3 Spacer
8-2 Washer
Fork
8-7 Spring Washer
8-1 16 mm Locknut
Middle
8-6 Front Axle Bolt
Left Side (Brake)
8-5 Spacer
8-2 Washer
Fork
8-7 Spring Washer
8-1 16 mm Locknut
8-1
8-3
8-2
8-7