Repair And Maintenance - Razor POWER CORE E100 Series Owner's Manual

REPAIR AND MAINTENANCE

Turn power "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power off
Adjusting the Brake
Required Tool: 10 mm Wrench (not included)
1
To adjust brake cable play, thread
the brake lever adjuster in or out 1/4
to 1/2 turn until the desired brake
adjustment is attained. Most adjust-
ments are complete at this step. If
brake still needs further adjustment,
proceed to step 2.
Front Tire Replacement
Required Tools: Two (2) 16 mm Wrenches (not included)
1
Using two (2) 16 mm wrenches, loosen the axle bolt.
Remove wheel and install replacement wheel.
(Note the sequence of the hardware)
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
• Secure the product under repair
• Exercise caution around
exposed parts
2
If brake is too tight or has too
much slack, use a 10 mm wrench
to loosen the brake cable and
adjust accordingly.
8-1
• Contact Razor customer service
if unsure about any repair or
maintenance
B B
3
Inspect the brake pads (A) for
proper alignment against the wheel
or excess wear. To realign brake
pads, loosen the fixing nut (B) and
adjust the pad to contact the rim.
Re-tighten and readjust as needed.
Verify proper brake function prior to
riding the scooter.
8-3 8-5 8-3
8-2 8-4 8-4 8-2
7
A A
Note: Front wheel
hardware sequence
Right Side (Throttle)
8-4 Spacer
8-3 Washer
8-2 Spring Washer
8-1 M10 locknut
Middle
8-5 Front axle bolt
8-1
Left Side (Brake)
8-4 Spacer
8-3 Washer
8-2 Spring Washer
8-1 M10 locknut