Safety Warnings - Juniper SRX 5600 Getting Started Manual

SRX 5600 Services Gateway Getting Started Guide
19.
20.
21.

Safety Warnings

WARNING: See installation instructions before connecting the device. This is a
summary of safety warnings. For a complete list of warnings for this device, including
translations, see the SRX 5600 Services Gateway Hardware Guide at
http://www.juniper.net/techpubs/hardware/
WARNING: The intrabuilding port(s) of the device is suitable for connection to
intrabuilding or unexposed wiring or cabling only. The intrabuilding port(s) of the
device MUST NOT be metallically connected to interfaces that connect to the OSP
or its wiring. These interfaces are designed for use as intrabuilding interfaces only
(Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and require isolation
from the exposed OSP cabling. The addition of primary protectors is not sufficient
protection to connect these interfaces metallically to OSP wiring.
CAUTION: Before removing or installing components of a device, attach an ESD
strap to an ESD point and place the other end of the strap around your bare wrist.
Failure to use an ESD strap could result in damage to the device.
CAUTION: An external Surge Protective Device (SPD) should be used at the AC input
of the services gateway.
22
Safety Warnings
Commit the configuration to activate it on the device.
[edit]
admin@# commit
Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the device.
[edit]
admin@host# commit
When you have finished configuring the device, exit configuration mode.
[edit]
admin@host# exit
admin@host>
.