Pitney Bowes DA Series Frequently Asked Questions Manual page 36

Get Addr (batch)
Get Addr (inter)
Hex Dump
IMAGE OVERLAY
INK CARTRIDGE
VOLUME
Ink Count
INVERTED PRINTING
IP Address
ISO CHARACTER SET
ITALIC
JOB SETTINGS
LANGUAGE
Letter (300)
LIGHT MODE
LINE SPACING
LINE TERMINATION
Lines per address
Logging Settings
LOW INK WARNING
MAINTENANCE COUNT
MODULE DISTANCE
NOZZLE KEEP ALIVE
ORIENTATION CONTROL
Paper Sensor
PERIODIC PURGE
Port Number
PRE-PURGE
PRINT BREAK CHARS
PRINT HEAD ADJUST
Overlay
PRINT QUALITY
Pulse Time (msec)
PURGE AT START
Purge Interval
Head assembly.
Raise paper guide.
Rising Edge
ROM Revision #
Signal Polarity
Stacker
Standard Feeder
STOP ON FEED ERROR
The milliliters (ml) of ink contained in the cartridge when full.
The amount of ink (drops) printed from the cartridge since new.
Inverting the entire image to be printed on the piece.
Part of the network setup when using ethernet communications.
see Symbol Set.
A settable font characteristic (DOS mode only).
A print quality selection.
A mode where vertical is altered from 600 dpi to 300 dpi by not
firing the second column on the print cartridge.
Used for DOS mode only sets lines per inch spacing.
Specifies character combinations to use as line termination
sequence.
The number of lines that all addresses have (DOS only).
Logs (if available) may have multiple levels of depth of event
logging.
The value at which the printer will show a low ink warning
message. Shown in % of ink volume for specific cartridge.
Total cycle count on hardware since new.
Mode where printer spits single nozzles on 'random' pattern.
Sensor before first print module used to control and trigger
printing.
A purge that happens on a time scheduled basis during while
printing a job.
aka PURGE AT START. A purge run before starting a job.
A overlay graphic added to each piece while printing.
Selected DPI value.
aka PRE-PURGE. Run a purge prior to start of printing a job.
Time between purges when a periodic purge is active.
Assembly that is raised or lowered by Media thickness
adjustment knob.
Version number for firmware installed in printer.
Output stacker selection option.
Page 36 of 37