Door Switch; Moisture Sensor; Motor, Heater, And Console Id - Kenmore Oasis 110.67032600 Manual

Power button controls Status
indicators at left
"More Time" controls
left digit of display.
DIAGNOSTIC: Door Switch
Opening the door should cause a beep and
an alphanumeric number to be displayed.
Closing the door should cause a beep and 88
to be displayed.
• If opening the door fails to cause a beep
and a number and letter to be displayed,
go to TEST #7.
DIAGNOSTIC: Moisture Sensor
Open the door and locate two metal strips
on the face of the lint screen housing. Bridge
these strips with a wet cloth or a finger.
• If a beep is heard and an alphanumeric
number is displayed on the console, the
sensor is OK.
• If not, or if a beep tone is heard before bridg-
ing the moisture strips, go to TEST #5.
Rotating knob turns
off indicators
" Less Time" controls Turns off all indicators and
right digit of display.
CONSOLE DIAGNOSTICS
Start button turns on Dryer.
Dryness Level
button controls
all indicators
exits diagnostic mode.
above button.
Figure 2.
DIAGNOSTIC: Motor, Heater,
And Console ID
Close the door. Press the Start button. The
motor and heater will turn on, and the display
will show one of the following console IDs:
A0, A2, A6, A7, A8, A9, or AA.
• If none of the Console IDs above are dis-
played, replace the user interface assem-
bly. See Accessing & Removing the Elec-
tronic Assemblies.
• If the motor does not turn on, go to TEST
#3a.
• If no heat is detected, go to TEST #4.
6-3
Temperature
button controls
Each button controls
all indicators
its own indicators.
above button.