Kenmore Oasis 110.67032600 Manual page 97

6. Access the moisture sensor by removing
the front panel. See Removing the Front
Panel/Drum Assembly. Disconnect the
sensor from the wire harness. See Fig-
ure 12, and refer to the wiring diagram
and strip circuit in Section 7.
Lint Screen
Housing
Disconnect sensor from wire harness.
Figure 12.
7. Measure the resistance across the outer-
most contacts of the cable that includes
the two MOVs.
• If a small resistance is measured, re-
place the moisture sensor and harness
with MOVs.
• Otherwise go to step 8.
8. Measure the resistance across each of
the outermost contacts and the center
terminal (ground connection).
• If a resistance less than infinity is mea-
sured, replace the moisture sensor and
harness with MOVs.
9. If moisture sensor diagnostic test pass-
es, check the thermistor: Perform TEST
#4a.
• If the problem persists after replac-
ing the moisture sensor, harness with
MOVs and thermistor, replace the ma-
chine control electronics.
Harness
with MOVs
Harness
Connection
6-29
TEST #6 Buttons and Indicators
This test is performed when any of the follow-
ing situations occurs during the Console But-
tons and Indicators Diagnostic Test:
• None of the indicators light up
• No beep sound is heard
• Some buttons do not light indicators
None of the indicators light up:
1. See Diagnostic Guide/Before Servicing.
2. Perform TEST #1, to verify supply con-
nections.
3. Perform TEST #2.
4. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control elec-
tronics.
5. Visually check the user interface assem-
bly connections.
6. If both visual checks pass, replace the
user interface assembly.
7. Plug in dryer or reconnect power.
8. Perform the Console Buttons and Indica-
tors Diagnostic test, to verify repair.
9. If indicators still do not light, the machine
control electronics has failed:
• Unplug dryer or disconnect power.
• Replace the machine control electron-
ics.
• Plug in dryer or reconnect power.
• Perform the Console Buttons and Indi-
cators Diagnostic test, to verify repair.
No beep sound is heard:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control elec-
tronics.
• If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.