Kenmore Oasis 110.67032600 Manual page 98

3. Perform the Console Buttons and Indica-
tors Diagnostic test to verify repair.
4. If replacing the user interface assembly
failed:
• Unplug dryer or disconnect power.
• Replace the machine control electron-
ics.
• Plug in dryer or reconnect power.
• Perform the Console Buttons and Indi-
cators Diagnostic test to verify repair.
Some buttons do not light indicators:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check the user interface assembly con-
nections.
• If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indica-
tors Diagnostics test to verify repair.
TEST #7 Door Switch
Activate the diagnostic test mode and perform
the Door Switch Diagnostic test.
Functionality is verified with a beep each time
the door is closed and opened, and a num-
ber and letter appears in the display (i.e., 0E,
09).
If any of the above conditions are not met:
• Unplug dryer or disconnect power.
• Check that the wires between the door
switch and machine control electron-
ics are connected. See Figure 13 for
switch location, and see Removing the
Front Panel/Drum Assembly.
Door Switch
Figure 13. Door switch location.
• If the connections are OK, replace the
door switch assembly and retest.
• If the door switch assembly has been re-
placed and dryer still does not start, re-
place the machine control electronics.
ADJUSTING CUSTOMER-FOCUSED
DRYING MODES
NOTE: If the customer is complaining about
the clothes being damp and the moisture sen-
sor passes TEST #5, step 3, the total dry time
for an automatic cycle can be lengthened by
changing from a "1" (standard auto cycle) to a
"2" (15% more drying time) or "3" (20% more
drying time) auto cycle.
1. Press and hold the Dryness Level button
for 5 seconds. The dryer will beep and
display CF for one second, then the cur-
rent drying mode will be seen on the dis-
play. The factory default value is "1".
2. To select a different drying mode, press
the Dryness Level button again. The dry-
er display will flash and show the avail-
able settings.
3. With the display flashing the selected
drying mode, press the Start button to
save the drying mode and exit (the Start
button in this mode does not start a dry-
ing cycle). The result will be stored in EE-
PROM of the control board, and will be
retained after a power loss.
4. Press the Stop button at any time to can-
cel changes and exit from this mode.
REMOVING THE FRONT
PANEL/DRUM ASSEMBLY
1. Unplug dryer or disconnect power.
2. Open the door.
6-30