Complete Installation Checklist; Reverse Door Swing (Optional) - Kenmore 110.70012 Series Use & Care Manual

Coin-operated commercial gas dryer
Table of Contents

Advertisement

Available languages

Available languages

Complete Installation Checklist

Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Check that you have all of your tools.
Dispose of/recycle all packaging materials.
Check dryer's final location. Be sure vent is not crushed
or kinked.
Check that dryer is level. See "Level Dryer".
Plug into a grounded 3 prong outlet. Turn power on.
Remove film on console and any tape remaining on dryer.
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
Read "Dryer Use" in your Use and Care Guide.
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
Dryer is plugged into a grounded 3 prong outlet.
Electrical supply is connected.
Household fuse is intact and tight, or circuit breaker has
not tripped.
Dryer door is closed.
When the dryer has been running for 5 minutes, open the dryer
door and feel for heat. If you feel heat, cancel cycle and close
the door.
If you do not feel heat, turn the dryer off and check to see whether
gas supply line shutoff valve is open.
If the gas supply line shutoff valve is closed, open it, then repeat
the 5-minute test as outlined above.
If the gas supply line shutoff valve is open, contact a
qualified technician.
NOTE: You may notice an odor when the dryer is first heated. This
odor is common when the heating element is first used. The odor
will go away.
14

Reverse Door Swing (Optional)

If your door is the Large Side-Swing Door, follow
steps 1-6.
If your door is the Super Wide Side-Swing Door,
follow steps 1-13.
NOTE: Magnetized screw driver is helpful.
Wide Model Large Side-Swing Door
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

110.70172 series

Table of Contents