Removing The Drive Motor And Belt Switch - Kenmore Oasis 110.67032600 Manual

REMOVING THE DRIVE MOTOR AND BELT SWITCH

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the cabinet front (see page 4-6
for the procedure).
4. Remove the belt and drum from the dryer
(see page 4-15 for the procedure).
5. To remove the drive motor:
a) Remove the nut from the drive motor
flywheel and remove the flywheel.
Drive Motor
Connector
Belt Switch
Blower Fan
Drive Motor
Flywheel
4-21
b) Single Motor Models Only: Remove
the blower fan belt from the blower pul-
ley. NOTE: It is important that you re-
install the belt properly to prevent the
blower from turning backwards. The
post on the blower housing (see step 5
on page 4-17) will interfere with the belt
if it is installed incorrectly.
c) Lift the top and bottom locking tabs on
the drive motor connector and pull the
connector off the motor.
Belt
Continued on the next page.
Top Locking Tab