Cycle Signal; Damp Dry Signal; Wrinkle Guard; Changing Cycles After Pressing Start - Kenmore Oasis 110.67032600 Manual

When the dryer is not running, the drum light
will turn on when DRUM LIGHT is pressed or
the dryer door is opened, and it will remain on
until the dryer door has been open for 5 min-
utes, the dryer door is closed or DRUM LIGHT
is pressed again.
Press DRUM LIGHT at any time to turn the
drum light ON or OFF.

DAMP DRY SIGNAL

Select the Damp Dry Signal to alert you that
your clothes are approximately 80% dry. This
is useful when you want to remove lightweight
items in a mixed load to prevent overdrying
or remove partially dry items that may need
ironing.
The DAMP DRY SIGNAL is useful when dry-
ing bedsheets/linens in a mixed load. When
the signal goes off, open the door to stop the
dryer, rearrange the load inside the dryer, close
the door and restart the dryer to finish the dry-
ing cycle. Rearranging the load will aid in the
drying process.
NOTE: The Damp Dry Signal is available only
with the Auto Dry Cycles.

WRINKLE GUARD

®
(30, 60, 90, 150 MINUTES)
WRINKLE GUARD
®
that may form when clothes are not removed
promptly at the end of a cycle. During this option,
the dryer stops tumbling and then tumbles again
for a brief period without heat when pressed.
• Press WRINKLE GUARD
periodic tumbling at the end of a cycle.
WRINKLE GUARD
stops the dryer, tumbling the load without
heat for 30, 60, 90 or 150 minutes (depend-
ing on your model) unless you open the
dryer door.
• Stop WRINKLE GUARD
pressing WRINKLE GUARD
dryer door or pressing STOP.
helps smooth out wrinkles
to get heat-free,
®
periodically starts and
®
at any time by
®
, opening the
®
• For the Casual Cycle, WRINKLE GUARD
is preset to ON. The other Auto Dry Cycles
will retain the WRINKLE GUARD
ting. For example, if you select WRINKLE
GUARD in the Normal cycle, WRINKLE
®
GUARD will be on the next time you select
®
the Normal cycle.
NOTE: If you do not select WRINKLE GUARD
the dryer stops after cool down.

CYCLE SIGNAL

CYCLE SIGNAL
The Cycle Signal produces an audible sound
when the drying cycle is finished. Promptly re-
moving clothes at the end of the cycle reduces
wrinkling.
Press CYCLE SIGNAL VOLUME until the
desired volume (Loud or Soft) is selected. On
some models, press CYCLE SIGNAL to turn
the Cycle Signal On or Off.
NOTE: When WRINKLE GUARD
a tone sounds every 5 minutes until the clothes
are removed, or WRINKLE GUARD
CHANGING CYCLES, MODIFIERS
AND OPTIONS
You can change Auto and Timed Cycles,
Modifiers and Options anytime before press-
ing Start.
• Three short tones sound if an unavailable
combination is selected. The last selection
will not be accepted.
CHANGING CYCLES AFTER
PRESSING START
1. Press STOP twice.
2. Select the desired cycle and options.
3. Press START. The dryer starts at the begin-
ning of the new cycle.
NOTE: If you do not press Start within 5 min-
utes of selecting the cycle, the dryer automati-
cally shuts off.
3-7
®
set-
®
,
®
is selected,
®
ends.
®