INSTALLATION INFORMATION
TOOLS AND PARTS
Gather the required tools and parts before
starting installation. Read and follow the in-
structions provided with any tools listed here.
Electric Models
•
Flat-blade screwdriver
•
#2 Phillips screwdriver
•
Adjustable wrench that opens to 1˝
(2.5 cm) or hex-head socket wrench (for
adjusting dryer feet)
•
Wire stripper (for direct wire installations)
•
Tin snips (new vent installations)
•
Level
•
Vent clamps
•
Caulking gun and compound (for installing
new exhaust vent)
•
Tape measure
Gas Models
•
8˝ or 10˝ pipe wrench
•
8˝ or 10˝ adjustable wrench (for gas con-
nections)
•
Flat-blade screwdriver
•
Adjustable wrench that opens to 1˝
(2.54 cm) or hex-head socket wrench (for
adjusting dryer feet)
•
Level
•
Vent clamps
•
Knife
•
Pipe-joint compound resistant to LP gas
•
Caulking gun and compound (for installing
new exhaust vent)
•
Pliers
•
Tape measure
SECTION 2
INSTALLATION INSTRUCTIONS
Parts supplied:
Remove parts package from dryer drum.
Check that all parts were included.
NOTE: Do not use leveling legs if installing
the dryer on a pedestal.
Parts needed:
Check local codes and with gas supplier.
Check existing gas supply, electrical supply
and venting. Read "Electrical Requirements,"
"Gas Supply Requirements" and "Venting Re-
quirements" before purchasing parts.
Mobile home installations require metal ex-
haust system hardware available for purchase
from your local Sears store or Sears Service
Center. For further information, please call
1-800-4-MY-HOME
2-1
4 leveling legs
(1-800-469-4663).
®