Kenmore Oasis 110.67032600 Manual page 100

ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies; the user
interface electronics, and the machine control
electronics. See Figures 16 and 17.
1. Unplug dryer or disconnect power.
2. Remove three screws from the rear of
the console assembly. Pull console to-
wards front of dryer to hinge open and/or
remove console.
REMOVING THE MACHINE
CONTROL ELECTRONICS
3. Remove the wire connections to the
machine control assembly.
4. Remove the one screw holding the
machine control assembly to the met-
al bracket. See Figure 16.
5. Push in on the tab located on the back
of the machine control to slide it off the
bracket. See Figure 16.
REMOVING THE MOTOR CONTROL
ELECTRONICS (DUAL MOTOR MODELS)
3. Remove the wire connections to the
motor control assembly. See Figure 16.
4. Remove the two screws holding the
motor control electronics assembly to
the dryer top.
User Interface Back Cover
Assembly Locking Tabs
Back Cover
3 Screws
Ribbon
Cable
Machine Control
Electronics
Assembly
Metal Bracket
Figure 16. Locate the electronic assemblies.
Communication
Harness
(Dual Motor
N.O. Heater
Model)
Black Relay 1
Screw
Motor Control
Electronics
Assembly
(Dual Motor
Model)
REMOVING THE USER
INTERFACE ASSEMBLY
3. Remove the wire connections from the
user interface assembly, including the
P5 ribbon cable. See Figure 16.
4. Remove the cycle selector knob from
the front of the console by firmly pull-
ing on it or carefully prying straight up-
ward.
5. The user interface assembly is held
to the console insert panel by three
screws and two locking tabs. After the
screws are removed, lift each of the
locking tabs to remove the back cover
of the user interface assembly. See
Figure 16.
6. Remove the cycle selector switch from
the user interface assembly opening
by lifting the locking tab on the cycle
selector switch and turning the selec-
tor switch in a counterclockwise direc-
tion. See Figure 18.
COM Motor
Blue Black
Red Relay
P9
1
5
Black-White
Tan
White
Green-Yellow
1
P8 Brown
Figure 17. Machine control electronics.
6-32
Yellow-Red
1
1
P13
P3
P5
8
1
P2
3
P14
1
Red-White
Open
6
3
P4
1
1
Black
Red-White