Installation Instructions; Tools And Parts - Kenmore 110.70012 Series Use & Care Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" nut driver or 5/16"
socket wrench
(recommended)
Tape measure
Level
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife

INSTALLATION INSTRUCTIONS

#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Putty knife
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing gas and electrical supply and
venting. See "Electrical Requirements," "Gas Supply Requirements,"
and "Venting Requirements" before purchasing parts.
8" or 10" adjustable
wrench (for gas
connections)
5