Copying An Ir Table For Uploading To Different Tvm-Rx03S; Uploading The Ir Protocol To A Tvm-Rx03 - AMX TVM-1600 User Manual

Advanced Administration
3. Upon completion a successful transfer message will be displayed (FIG. 44).
FIG. 44 Successfully loaded the iSonyLCD protocol to port 1

Copying an IR table for uploading to different TVM-RX03s

It may be necessary to copy the file iXXX.001 to other files named iXXX.002 through iXXX.016 in
order to upload the IR files to TVM-RX03 units on all ports of the TVM-1600.
For example, if you used tftp to get an IR file from a TVM-RX03 unit on port 1, your file will have a
.001 file extension. To send this file to a TVM-RX03 on port 16 it would need a file extension of .016.
To copy an IR table to different TVM ports;
1. At the command prompt on the PC navigate to where the IR table is saved.
2. Use the Copy command (FIG. 45) to copy the IR files to different extensions;
FIG. 45 Copying the iSony LCD protocol from port 1 to port 16
3. Upon completion a successful transfer message will be displayed (FIG. 46).
FIG. 46 Successful copy of IR protocol from port 1 to port 16

Uploading the IR protocol to a TVM-RX03

To upload this IR file to a TVM-RX03 unit on port 16 of the TVM-1600 hub, now use the tftp command
with the new file iSonyLCD.016.
1. Open a command session.
2. Type in the following command;
3. Push Enter to execute the command.
34
copy iXXX.001 iXXX.016 <enter>
Where XXX is the file name of the IR table (e.g. iSonyLCD) and .001 represents the port
number of the TVM-1600, where the IR table resides.
And
Where XXX is the file name of the IR table (e.g. iSonyLCD) and .016 represents the port
number where the IR protocol is to be copied to on the TVM-1600.
tftp –i 192.168.1.200 put isonylcd.016
TVM1600 16 Port Managed TV Distribution Hub - User Guide