Components Required; Configuring A Display Device's Ir Protocol; Learning The Ir Protocol Used By The Display Device - AMX TVM-1600 User Manual

Components required

FIG. 36
TVM Hub (front panel)
FIG. 37 TVM RX-03 (FG-TVM-1600-RX03)
FIG. 38 IR Blaster (TX)

Configuring a Display Device's IR protocol

The two stages for learning IR Protocols are:
1. Train the TVM-RX03 to understand the timing sequences of the display device remote control
protocol.
2. Learn the actual IR code for specific functions on the device's remote control e.g. power off.

Learning the IR protocol used by the display device

1. Ensure a console session has been opened on the Managed TV hub. The configuration settings for
the Terminal session are:
2. A TVM-RX03 unit needs to be connected to port one of the hub.
3. At the command prompt enter the following command:
4. Push Enter to execute the command. The process will then guide you through what to do;
TVM1600 16 Port Managed TV Distribution Hub - User Guide
• Baud Rate: 9600 bps
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
r init X
Where X is the port number that the TVM-RX03 unit is attached to. It can be a value
from 1 to 16.
Point the remote control at the IR port (Right Window Only) on the front of the hub and
press any key on the remote when prompted.
front
rear
Advanced Administration
31