Indoor Installation - American Dynamics SpeedDome Ultra VI Installation And Service Manual

When using the standard base and wiring
cables directly to the dome, ALWAYS connect
the video cable to the dome before you connect
the 9-pin cable (which contains power). If you
connect the 9-pin cable first, you risk shorting
delicate electronics near the connector.
I/O PC board (when used).
− If a cable clamp is on this board, remove it,
as it could damage cable connectors in the
housing during assembly.
− Use a jeweler's 2.5mm (0.1") slotted
screwdriver to tighten connector screws. Do
not over tighten these screws.
− Use the dust cover when shipping the I/O
board back to the manufacturer. It will protect
the spring-finger connector.
When connecting the housing and eyeball
assembly to an outdoor housing:
− Remove both slot covers to keep the camera
from overheating.
− Keep cables entering the housing away from
the heater assembly.
− Place tubing around the BNC connectors to
avoid shorting their metal surface to the
outdoor housing.
− Check heater fans. Both fans must be on to
prevent overheating.
Note: For further information, see installation
instructions shipped with the outdoor housing.
If disassembling the dome:
− Dome contains electrostatic-sensitive
devices! Use a ground strap when handling
PC boards.
− Once disassembled, parts of housing and
eyeball assembly are "extremely fragile" and
may break. Proceed using extreme care!
SPEEDDOME ULTRA VI
INSTALLATION AND SERVICE GUIDE

Indoor Installation

This section explains how to connect the housing
and eyeball assembly to a:
• Standard mounting base
• Mounting base with I/O board.
Items You Will Need
You should have on hand the following
tools and parts:
Install/Removal tool to attach and detach domes
and bubbles without a ladder from mounting
bases with I/O boards.
Base kit:
− RUIOB/RUWIOB (base with I/O board), or
− RUPTB/RUWPTB (standard base).
Housing and eyeball assembly, 0100-2477-XX.
The -XX determines the type of camera used.
-01 = Color NTSC (for dome with black finish)
-02 = Color PAL (for dome with black finish)
-03 = Color NTSC (for dome with white finish)
Other Preparations
To ensure a smooth and successful
installation, you must:
Have electrical work comply with latest national
electrical code, national fire code, and all
applicable local codes and ordinances.
Coordinate work with other trades to avoid
interference.
Verify existing site conditions and coordinate
with the owner's representative and appropriate
utilities as required.
Obtain copies of all related plans, specifications,
shop drawings and addenda to schedule and
coordinate related work.
Thoroughly review the project to ensure that all
work meets or exceeds the above requirements.
Bring alleged discrepancies to the attention of
the CCTV Project Coordinator.
11
of 34
8000-2830-03, REV. C