American Dynamics SpeedDome Ultra VI Installation And Service Manual page 27

Detaching the Eyeball
1. Perform procedure "Removing the Slot Covers"
(page 29).
2. Perform procedure "Removing the Camera"
(this page).
3. Detach eyeball from housing (Figure 28).
a. Turn yoke to access tabs. One tab is more
accessible than the other. Use your finger to
press this tab while, simultaneously, using a
small slotted screwdriver to press the other.
b. While pressing tabs, push up on eyeball to
detach it.
Figure 28. Loosening the eyeball
4. Detach slip ring connector (Figure 29).
Figure 29. Detaching the eyeball
SPEEDDOME ULTRA VI
INSTALLATION AND SERVICE GUIDE
Removing the Camera/Lens
Board
1. Perform procedure "Removing the Slot Covers"
(page 29).
2. Perform procedure "Removing the Camera"
(page 29).
3. Perform procedure "Detaching the Eyeball"
(page 30).
4. Separate yoke brackets (Figure 30).
Figure 30. Separating the yoke brackets
5. Gently pry off yoke bracket covering
camera/lens board to access bearing
assembly (Figure 31).
Figure 31. Removing the yoke brackets
27
of 34
8000-2830-03, REV. C