American Dynamics SpeedDome Ultra VI Installation And Service Manual page 29

6. Access tilt motor.
To do this, loosen captive retaining screw
holding tilt cable assembly in place and gently
remove this assembly.
7. Remove tilt motor (Figure 35).
Lift motor housing up as shown (1) to disengage
motor from tilt gear. Then pull motor bracket
towards outside of cable/tilt assembly (2) to
remove motor.
Figure 35. Removing the tilt motor
8. Reverse steps to reassemble.
CAUTION: When installing a new motor, be
careful to properly mesh motor and tilt gears!
Failure to do so can destroy both motor and tilt
gear. Verify tilt gear turns freely!
SPEEDDOME ULTRA VI
INSTALLATION AND SERVICE GUIDE
Tilt Motor
(Lift up, then out.)
29
of 34
Updating/Reprogramming
Dome Software
CAUTION: This procedure involves extracting a
flash memory chip, an electrostatic-sensitive
device. Use a ground strap when handling the chip.
To update or reprogram dome software:
1. Insert the chip extractor tool into the square
access hole and squeeze the tool to extract the
flash memory chip (Figure 36).
2. Reprogram the chip or replace it with a new
one.
3. Align the dot on the chip with the indent on the
socket, and then push down on the chip to
reinsert it.
Figure 36. Removing the flash memory chip
8000-2830-03, REV. C