American Dynamics SpeedDome Ultra VI Installation And Service Manual page 6

Outdoor Mounting (Optional)
Note: This document does not include outdoor
installation and service instructions. For these
instructions, see Installing the RHODUL Outdoor
Housing, 8000-2573-04.
The camera dome attaches to outdoor walls and
ceilings using an RHODUL outdoor housing
(Figure 6) and one of the following optional
mounting structures (Figure 8):
• RHOTR Over Roof Mount
• RHOTRF Over Roof Floor Mount
• RHOPN Pendant Mount
• RHOWPA Pole Mount
• RHOSW/RHOLW Wall Mount
• RHOWCA Corner Bracket.
The outdoor housing contains a pre-installed
mounting base, a cooling fan for hot weather, a
heater for cool weather and to prevent icing, and
surge protection circuitry to protect against
lightning strikes.
An environmental PC board is used to pre-wire
cables. A round spring-finger connector on the
board makes electrical contact with the housing
and eyeball assembly as it connects to the base.
Note: Do not use the I/O board (designed for
indoor use) in place of the environmental board.
Figure 6. RHODUL outdoor housing (optional)
SPEEDDOME ULTRA VI
INSTALLATION AND SERVICE GUIDE
SpeedDome Housing Adapter
Bracket (Optional)
An RHSDA adapter bracket (Figure 7) enables the
dome to fit into SpeedDome indoor and outdoor
housings. Locking pins in the bracket enable the
dome to swing out for servicing or removal.
Figure 7. RHSDA adapter bracket (optional)
6
of 34
8000-2830-03, REV. C