Installing The Indoor Unit; Figure 2-8: Indoor Unit Connected To Switch/Router/Hub; Figure 2-9: Indoor Unit Connected To Host Computer - Alvarion BreezeACCESS LB System Manual

Chapter 2 - Installation

Installing the Indoor Unit

Once the LB NI-01 Indoor unit and the LB RE-01 outdoor unit are
connected, the LB NI-01 Indoor unit is ready to be installed and
configured. The Ethernet data rate is determined automatically,
depending on the type of device connected to the system.
If the LB NI-01 Indoor unit is used for connection to a core network, the
network device is likely to be a router, hub, or switch as shown in
Figure 2-8. In this configuration, a crossover Ethernet cable is required
to connect between the LB NI-01 Indoor unit and the network device.

Figure 2-8: Indoor Unit Connected To Switch/Router/Hub

The LB NI-01 Indoor unit may also be connected directly to the host
computer, as shown in Figure 2-9. In this configuration, a straight-
through CAT 5/UTP cable is required to complete the connection.

Figure 2-9: Indoor Unit Connected To Host Computer

2-10
BreezeACCESS LB System Manual