Table of Contents
Advertisement
Error Details
LB NI-01 PLL Error: The PLL (Phase Locked Loop) section within the
LB NI-01 Indoor unit experienced an error. The System Fault LED may
light. Action: Try resetting the unit.
Communication Error Over IF Cable: Communication between the LB
NI-01 Indoor unit and the LB RE-01 Outdoor unit failed. Action: Check
the IF cable and connectors.
Radio High Temp. Warning: The LB RE-01 Outdoor unit's internal
temperature rose above 185F / 85C. Action: The LB RE-01 will shut
down for 30 seconds to allow cooling time.
Radio Power Supply Fault: Indicates a fault in the LB RE-01's power
supply. This error could be due to a problem with the internal power
supply, or with the power source from the LB NI-01 Indoor unit. Action:
If the Low DC Voltage At radio error is also indicated, (see below) check
the IF cable and connectors. If the Low DC Voltage at radio error is not
indicated, the LB RE-01 Outdoor unit will require servicing.
Low DC Voltage At radio Input: The DC voltage at the LB RE-01
outdoor unit (carried by the IF cable from the LB NI-01 Indoor unit) is
lower than the required 24VDC. Action: Check the IF cable and
connectors.
Ethernet LAN Statistics
Rx packets: Counts the number of packets successfully received by the
local system.
Rx packets - Discarded: Counts the number of packet errors received
by the local system.
Tx Packets: Counts the number of Ethernet packets transmitted by the
local system.
Wireless Statistics
Received Signal Strength – Min: Indicates the minimum received
signal strength measured since the last screen refresh.
Received Signal Strength – Mean: Indicates the average received
signal strength, computed since the last screen refresh.
Received Signal Strength – Max: Indicates the maximum received
signal strength measured since the last screen refresh.
System Status
3-19
Advertisement
Table of Contents
Troubleshooting
