Wireless Configuration; Table 3-2: Wireless Channel Center Frequencies - Alvarion BreezeACCESS LB System Manual

Chapter 3 - Commissioning

Wireless Configuration

RF Channel: specifies the operating channel of the system, within the
100 MHz available in the 5.8 GHz band. The table below specifies the
center frequencies of each permitted channel.

Table 3-2: Wireless Channel Center Frequencies

Channel
1
1A
2
2A
3
3A
4
4A
5
To avoid interference, two PTP links operating in the same physical
location (co-located) or within close proximity must be separated by at
least one channel, i.e., the gap between channels must be 20 MHz or
more (e.g., channels 2 and 3). Refer to
Broadband, for further information regarding deployment conventions.
Max Tx Power: this parameter specifies the maximum power level of
the system. Depending on the RF channel and FCC regulations, the
software will determine the actual power to be used, which will not
exceed this user defined value. Refer to Table 3-3 below. The Actual
Tx Power is displayed on the System Status page.
The Actual Tx Power is set by the software / firmware to the maximum
power permitted for each channel according to the modulation scheme,
as shown in the following table:
3-12
Frequency
5735 MHz
5745 MHz
5755 MHz
5765 MHz
5775 MHz
5785 MHz
5895 MHz
5805 MHz
5815 MHz
Chapter 5 – Wireless
BreezeACCESS LB System Manual