Installation Requirements
100 – The "100" LED lights solid and green when the Ethernet port is
operating at 100 Mb/s. The LED will not illuminate if the port is
operating in 10 Mb/s mode. The Ethernet port automatically selects the
speed through auto-negotiation with either the host computer/server or
router/switch.
FD – The "FD" LED illuminates solid and green when the LAN
connection is operating in Full Duplex mode. The system automatically
selects the duplex mode through auto-negotiation with the host
computer or switch.
Col – The "Col" LED flashes in amber when collisions are detected on
the Ethernet port.
The LAN Interface
The LAN interface is a 10/100 Base-T Ethernet port, which is used to
connect the LB NI-01 Indoor unit to either the core network or to a host
computer. A router or switch is often used to complete the connection to
the core network, as shown in the figure below. Note that different
cables are required for connection to a hub/switch/router or host
computer. See
Installing the Indoor Unit
on page 2-10 for more
information regarding installation of the LB NI-01 Indoor unit.
Figure 2-4: LAN Interface
2-5