Care Of Glass; Cleaning The Glass Ceramic Sheet; Flat Door; Angled Door - Spartherm Varia M60h Installation And Operating Instructions Manual

7.6 CARE OF GLASS

WARNING
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
If the glass is not kept clean permanent discolouration
and / or blemishes may result. Normally a hot fire will
clean the glass. The most common reasons for dirty
glass include: not using sufficient fuel to get the appli-
ance thoroughly hot, using green or wet wood, closing
the draft so far that there is insufficient air for complete
combustion. If it is necessary to clean the glass, buff
lightly with a clean dry cloth and non-abrasive cleaner.
DO NOT CLEAN GLASS WHEN HOT! Clean the glass
after the first 10 hours of operation with a suitable
stove glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel
rest or fall against it and always close the door gently.
NEVER FORCE IT SHUT!
If the glass should ever crack or break while the fire is
burning, do not open the door until the fire is out and
do not operate the appliance again until the glass has
been replaced, available from your Authorized dealer.
DO NOT USE SUBSTITUTE MATERIALS.
7.7 CLEANING THE GLASS CERAMIC
SHEET
WARNING
THE GLASS CERAMIC SHEET MAY ONLY BE
CLEANED WHEN COLD (FIREPLACE INSERT NOT
BURNING AND COOLED DOWN; NO HOT ASH IN THE
FIRE CHAMBER).
WARNING
AVOID BURN RISK. REMOVE OPERATIONAL TOOL
AFTER USE!!!
P o s i t i o n
„operational tool"
on the lever at
the bottom right
h a n d l e s i d e o f
the door. Push the
door to the top."

7.7.1 FLAT DOOR

1. Close the fire compartment (slide down fully).
2. From the left, place the "operational tool" on the
catch located centrally above the fire compartment
door.
3. Then tip the door to open.

7.7.2 ANGLED DOOR

1. Slide down the fire compartment door fully.
2. Using the "operational tool", twist open the catch for
the sliding rail locking mechanism, located above
the fire compartment door, right and left. The door
is now locked in bottom position.
t h e
Using one hand, tilt the door open up
to its end stop.
Another locking bolt is located on
the opposite side.
3. Release the lateral door catches by hand, or with
the "operational tool", by twisting – observe the
sequence. Important: First release the bottom catch,
then the top one. (the top catch supports opening).
Then twist open the top catch.
58
4. Swing open the fireplace door to the left and/or
right.
Handle the doors by their frames only!

7.8 CARE OF PLATED PARTS

If the appliance is equipped with plated parts, you
U n l a t c h b y
must clean fingerprints or other marks from the plated
twisting to the
surfaces before operating the appliance for the first
right.
time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the first
time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fingerprints
and oils will not affect the finish and little maintenance
is required, just wipe clean as needed. Prolonged high
temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best
removed when the assembly is at room tempera-
ture but this can be improved if the assembly
is warmed, using a hair dryer or similar heat
source.