Page 2
PREFACE / QUALITY PHILOSOPHY You have decided in favour of a Spartherm Magic fireplace insert. Thank you for showing confidence in our product. In a world of surplus and mass pro- duction, our company stands for the values expressed by our owner, Gerhard Manfred Rokossa: „High technical quality combined with contemporary design and service to the...
CONTENTS 1. Certified quality 6. Cleaning and care 6.1 Washer 2. Rating plate 7. Help 3. Fuel 7.1 Glass becomes sooted heavily, rapidly and unevenly 3.1 Wood 7.2 Fire is difficult to ignite and maintain 3.1.1 CO Neutrality 7.3 Smoke fills the room during refuelling 3.1.2 Basic requirements for installing an open fireplace 7.4 Too high a rate of burning or wood consumption 3.1.3 Amount of wood...
A = not a self-closing door • open operation possible under certain conditions For the Magic fireplace insert, the rating plate is located in the internal • does not allow multiple connection of the flue recessed inspection door below the firebox door. To reach the inspection door, the firebox first has to be rotated (see „4.2.1 Starting a fire for begin-...
3. FUEL 3.1.2 BASIC REQUIREMENTS FOR INSTALLING AN OPEN FIREPLACE 3.1 WOOD All types of wood contain about the same amount of thermal energy per kg 3.1.1 CO NEUTRALIT Y of net wood mass. Each type of wood has a different volume at the same weight, though, because the cells from which the timber is constructed have The „Wald in Not“...
Here are some helpful tips and information: Wood briquettes pursuant to Segment 3 of the BImSchV [German Fed- • The best fuel is air-dried, untreated firewood with a residual moisture eral Immission Protection Ordinance] may also be used. These include content of ≤...
CAUTION! When To be able to ignite the Magic fireplace insert, the firebox first has to be monitoring loading and ventilation, WC ventilation and exhaust hoods rotated 180°.
Page 8
The firing door can be locked for a short time for cleaning purposes. For this purpose, push the locking mechanism (which is located on the bottom right Light the pyre, close the fire door, and turn the when the firebox door is tilted) towards the bolt and connect it. To close the firebox by means of the control handle (using the door, open this slightly more than the current 90°.
4.2.2 BURNING 4.3 STARTING A FIRE FOR PROFESSIONALS Principle: This lighting method is a simple and effective way to reduce • Depending on the weather conditions, move the control lever more or less to the middle position or slightly above it (closing the air supply). This emissions from fireplaces.
Page 10
For this purpose, turn the control lever until it is approximately in the middle position. If the flames Light a match and ignite the two or three firelighters. become very weak at this point, turn the lever to the left (towards „+“) to reopen the air supply. At this stage, it may be useful to frequently regulate the amount of air.
• Before starting a fire, empty the ash pot and the ash grate. Insert the ash peratures of more than 300 °C may occur on the glass pane. Always use grate with the printed Spartherm logo facing downwards. the supplied heat-resistant glove.
5.3 PROTECTION IN THE AREA OF THE FIREBOX 5.3.1 SPECIAL PRECAUTIONS FOR THE FIRE PROTEC- OPENING TION OF FLOORING INSTALLED IN THE DIRECT VICINIT Y OF FIREPLACES Where the floor area to the front of an open fireplace is made of flammable materials, these must be protected at the front by a covering of non-flam- Carpets and parquet flooring must be protected from spark emission using a mable material to the height of the andiron or firebox base (floor height plus...
5.4 CLEANING THE GLASS CERAMIC PANES ON THE SLIDING DOORS Cleaning the glass ceramic panes on the sliding doors can only take place It is normal for the glass pane to become covered with soot; this would not in the cold state (when the firebox is not burning and has cooled; no hot justify a complaint.
7.2 FIRE IS DIFFICULT TO IGNITE AND MAINTAIN If this did not occur from the outset, please look into the following issues: You should only call your local dealer/fireplace fitter if no improvement • Have the correct burning materials and equipment been used? occurs after you have been able to answer all of these questions with „yes“.
The product must, therefore, only be installed and commissioned into service by specialist technical staff, in compliance with current statutory Spartherm Feuerungstechnik GmbH is not obliged to satisfy any claim if provisions. such documentation is not presented. 8.3 WARRANT Y PERIOD 8.5 EXCLUSION OF GUARANTEE...
Damages and claims for compensation which are not the result of delivery • incorrect installation or equipment connection of a defective device from Spartherm Feuerungstechnik GmbH are excluded • failure to comply with installation guidelines or operating instructions and are not part of this warranty promise.