Table of Contents
Advertisement
Main Room: Installing the Television Wall Plates
1. Connect all the television cables to wall plates. You will need one, two or three wall plates, depending on the wall plate
system you choose.
2. Connect the following six cables to wall plate connectors that have an RCA jack inside and outside:
A. Composite Video
B. Red (Pr)
C. Green (Y)
D. Blue (Pb)
E. Audio Left
F. Audio Right
3. Label the wall plate outputs. Remember that many of the connectors will look the same.
4. Connect the RF cable to a wall plate connector that has an F-connector female inside and outside.
5. Label the RF wall plate output.
6. Connect the infrared (IR) remote control cable to a wall plate connector that has a 1/8-inch minijack (female).
A. Use a cable stripping tool to strip off about two inches of the jacket insulation.
B. Untwist each conductor and spread the conductors out.
C. Strip off 1/4-inch of insulation and connect the White/Orange conductor to the tip terminal of the minijack.
D. Strip off 1/4-inch of insulation and connect tithe Orange conductor to the sleeve terminal of the minijack.
7. Label the IR remote control wall plate output.
8. Screw the wall plate(s) into the junction box.
9. Affix the face plate(s), if necessary loosening the wall plate screws for a snug fit to the wall.
Main Room: Connecting the Television
1. Use RCA cables to connect the Red (Pr), Green (Y) and Blue (Pb) wall plate connectors to the "Video 5" component video inputs
of the television. In the case of a Sony plasma television, use the "Input 2" component video inputs.
2. Use an RCA cable to connect the Composite Video wall plate connector to the "Video 1" composite video input of the television.
3. If your System Rack has no cable, satellite or other set-top box, use a coaxial cable to connect the RF wall plate connector to the
"RF input" of the television.
4. If your System Rack has no cable, satellite or other set-top box, use RCA cables to connect the Left Audio and Right Audio wall
plate connectors to the Left and Right Audio outputs of the television
5. Attach an IR remote control flasher to the infrared remote receiving window of the television.
6. Insert the 1/8-inch miniplug of the IR flasher cable into the IR remote control wall plate minijack.
Installation
39
Advertisement
Table of Contents
