Table of Contents
Advertisement
Programming
4. Connect the dedicated RM-TP100 programming cable to your laptop RS-232C interface. If your laptop PC does not have an
RS-232C interface, you may also need a commercially-available USB-to-RS-232C converter.
5. Launch the RM-TP100 Editor application on your laptop PC by clicking on a shortcut or double clicking on the
RM-TP100Editor.exe icon.
6. Click the Open File button — — and then locate and select the desired GUI file:
System
For NO cable, satellite or other set top box.
For video front projector
7. Click the Upload to RM button — — (red up-arrow) Uploading will start. When upload is complete, you will see a message,
"Upload Completed!" This takes about ten minutes.
8. Disconnect the programming cable from the RM-TP100.
9. Close the connector cover.
A. Insert the two tabs of the connector cover into the notches on the RM-TP100 by lifting the connector cover up,
as shown.
B. Push the lower part of the connector cover into the hole.
C. Push the upper part of the connector cover into the hole.
22
NHS-3020
NHS-2020
3020_NO_CABLE.gui
2020_NO_CABLE.gui
3020_Front.gui
2020_Front.gui
NHS-1020
1020_NO_CABLE.gui
1020_Front.gui
Advertisement
Table of Contents
